This Web site uses the same credentials as the SEPM Console. If the SEPM Web server service is running, and not blocked by a firewall, you will be prompted to log in to the Reporting Web site. Change the Reporting port to an unused port on the SEPM computerīrowse to the SEPM Reporting Web site ( by default).In the Management Server Configuration Wizard, select Reconfigure the management server, ensure Use a recovery file to restore communication with previously deployed clients is checked, and click Next.To correct the port conflict, follow the steps below on the SEPM server: If this command shows any process listening on the SEPM Web server port, re-run the Management Server Configuration Wizard, and reconfigure the SEPM Reporting server port.If the Symantec Endpoint Protection Webserver service is stopped and fails to start, confirm that no other process is listening on the SEPM Reporter Web site port (default: 8445). If the STATE returned by this command equals "4 RUNNING", log off and log back on to the SEPM Console.This command should return a STATE value of "2 START_PENDING".If the STATE returned by this command does not equal "4 RUNNING" enter the following command and hit Enter:.Enter the following command and hit Enter:.Open a command-prompt window as Administrator.Confirm the Symantec Endpoint Protection Manager Webserver service is started
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |